Does anyone have an orignal depth gage for the large frame tiller? I am sure I can make one but I would like to get it as close to original as I could.
Depth gauge
Deerlope
1 - 20 of 20 Posts
Joined
·
526 Posts
i can get u pics and measurements later today
Joined
·
702 Posts
I agree, I use them on the round backs for the tubers.
Joined
·
526 Posts
forgot to check on the depth guage for ya... was busy working on the car all day. will try to remember tomorrow!
Joined
·
526 Posts
ok went out and took some pictures. i believe its the orig depth guage, still has some factory red paint on it. its made out of 1/2" thick steel. is 9" long overall, the center of the middle hole is 4.5" from the "long" end, each hole is 1" on center from the next. hope this helps!
Attachments
Joined
·
3,480 Posts
I would almost bet those are 5/8" holes as that is what everything is on the LF. That looks to 2" x 9" x 1/2" flat bar. I know I got some flat bar in the shop so now I can make up 2 of them.
Joined
·
5,525 Posts
There half inch by what I know and the pics.
Joined
·
526 Posts
believe it is half in as well, - definately smaller holes and uses smaller pins than any of the other attachments and lift arms
Joined
·
526 Posts
went out to recheck, the bar is 1 1/2" wide. the holes are centered so the bar can be reverses and the other end used.
its actually about 34".. by looking at the pics, just mark 1" down on one side and cut on that diagonal to the other tip.
g'luck, glad i could help, and post some pics of what u come up with!
1 - 20 of 20 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
