Yeah, I haven't been out since last Monday. Good thing we keep a lot of stuff on hand. Well that and that our frequent visitors (UPS, FedEx, and USPS) are still active. I think I'll be here for months.
I added this length of hose on the oil pan drain. Actually I added it shortly after I bought the bought the machine and changed oil the first time and had the oil run on the drive shaft boot and make a mess. But I never remembered to share it here. I'm sure some of you did the same thing, for those that didnt it's just a piece of 5/8" heater hose and a hose clamp. Could prolly get by with 1/2" but all I had here was 5/8". Need about 4" minimum too make a difference, could go up to 6-8" long without it sticking down lower than the front axle.
I bought this LT155 and the wiring was all rigged. I was able to figure it out except for the charging.
The wires were burned at the plugs from voltage regulator to the relay.
The picture above shows the red wire from B+ going to a splice which goes to the key switch and solenoid and...
X585 having issues keeping drive shaft PTO collar from coming off (runs the mower) locks on when installing but flies off when using. History of collar won't come off that I had replaced now I almost wish I had that problem back. Anyone else that has had this problem and what should I be...
Looking for this part (AM132613) for the rear PTO kit for my X585. JD says I need it but it is discontinued.
Found an aftermarket but really pricey and I don't know anything about the part so don't want to just blindly order it!
So I bought this 455 about 2-1/2 years ago in mechanically-sound-yet-cosmetically-hurting condition. It has run flawlessly the entire time. But, it's time to show the ole girl a little love I think.
There are a few reasons for doing this. Primary objectives:
Fix rear end leak
Remove JD Cat...
So I bought an extra muffler on eBay figuring that it wasn't good due to the price, but looked good enough that if I can fix it this might be something members would like to see done. Well it came yesterday and when I shook it there were a lot of loose metal parts inside. Also the end where...