My Tractor Forum banner
Cancel

X740 wire to nowhere

1261 Views 13 Replies 6 Participants Last post by  Notkaren, 
Notkaren
3
Was under the hood today and noticed this wire harness was not plugged into anything. I can't seem to figure out what it is for. The wires are green and black. Can anyone enlighten me to what it goes to?

I did not receive any voltage reading when I tested it. I tested it while the engine was on, off, and also turned the light switch on and off.


thank you to all

*I posted this on another forum earlier because I had forgot my password here. I have not received any solution.

Attachments

See less See more
Reply
Save
Like
1 - 2 of 14 Posts
S
Do you have a RIO? If so, it might be for the RIO bypass switch connection when using a front mounted implement like a Broom or Snow Blower.
Reply
Save
Like
S
If you have the front PTO installation Kit, it will have a sensor that you plug the harness into. There will be a pulse generated by that sensor that will over ride the RIO so you can backup without having to hold the RIO switch up.
Reply
Save
Like
1 - 2 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
My Tractor Forum
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
John Deere Forum Craftsman/Sears Forum Backyard Round Table: L & G Tractor Related Topics Introductions Walk Behind Mowers
Top