Well for just $19.95 we can start one today. Plus if you send pictures with in the next 5 minutes and fill it up we will start a new one for free. Harry and call now this offer only last 10 seconds. Oh no I am sorry you were to late.Well we will be back with this great offer this Xmas. :sorry1:
:dunno: Shhhh,
more demand would just increase our costs more than what they are now.
I like being a little under the radar, we know what we got.:thThumbsU
Hello all, it has been a while since I've posted. I would like to know where the wires for the ignition, hour meter and amp meter are routed up. Unfortunately I didn't take a photo before every thing was dismantled. It appears that they should come up behind and in the middle of the oil...
Pulled engine out .Rear seal was out. Cleaning up the mess. Has 825 hrs on it. Any suggestions on doing anything else to it while it is out? Maybe head gaskets. One maybe leaking oil. Better safe then sorry. Don't know if they had issues with them or not? I'm sure someone knows more about them...
Some quick pictures and a drawing for making some 4 lug trailer spindles a mild "slip on" fit over your 3/4" spindles.
I gave them a few good smacks with a block of wood and a deadblow until the outside cotter pin lined up. I burned them in with a good hot stitch of weld after as well.
I...
My lawn tractor starts and runs for about 10 seconds and then dies. Won't restart for 10 minutes. However, If I supply starting ether it will run continually.
Day 2 of ownership I lost all forward and reward motion. Some trouble shooting led me to pull it apart. Now I'm on the hunt for a new right hand rear axle.
Also, the axle came out by just removing a Cotter pin, is this normal or is there supposed to be a c clip as well?
Thanks!
A forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
