U Joint removal 995

2076 Views 8 Replies 3 Participants Last post by Hydronerd, Nov 3, 2015

smartel

Discussion Starter · Oct 30, 2015

Good day you all,

I am trying to remove this u-joint from the Eaton pump, I does not seem to have any clips to dismantle it, is this a sealed unit?

I have read in this forum that the yoke is just fitted with a key on the shaft on the 990, is it the same on this one? Same pump must be the same....but it does not seem like it.

Any kind of help is needed...
Thank you!

See less See more

Save

1 - 4 of 9 Posts

smartel

Discussion Starter · #3 · Oct 30, 2015

Thanks VTXRider,

I have seen the puller, and it seems to work well, but the U Joint has to be dissambled to use and mine appears to be sealed. I will soak with PB for a while and try again, thanks for the picture I didn't find one that was that clear.

I'll post results to let you know

Save

smartel

Discussion Starter · #4 · Nov 1, 2015

I had to sacrifice the U-Joint, not the same as my 990 anyway and the drive shaft was welded to it, so unusable for me. I used a puller to remove it, it took a lot of patience not to use the BFH, lots of soaking, but it is out now and I saved the fan!

See less See more

Save

smartel

Discussion Starter · #8 · Nov 2, 2015

Thank you guys for your help,

I don't need to rebuild these joints, I will use the ones one my 990, so I am fine. Thanks for the info.

@Hydronerd #44 is the circlip holding the FAN on the U-Joint assy

Save

1 - 4 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

U Joint removal 995

smartel

Attachments

smartel

smartel

Attachments

smartel

Top Contributors this Month