My Tractor Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
618 Posts
Discussion Starter · #1 · (Edited)
I am replacing the o rings and gaskets on my K91. I am following the manual as well as two YouTube videos.
I thought I was making good progress, but cannot seem to get the motor case off. I removed 2 snap rings and the 5 bolts. Am able to pull the case a little bit away from the charge pump, but not enough to get my fingers in. This seems really stubborn to the point I have to have missed something.

Any thoughts? Seems like the bearing stays out in the removal. Am I wrong?
Automotive tire Gas Automotive wheel system Auto part Machine


Tire Motor vehicle Automotive lighting Automotive tire Hood
 

·
Registered
Joined
·
618 Posts
Discussion Starter · #3 ·
Nevermind, of course, try something forever without success. Ask for help and it immediately comes off. Must be slacking on my Wheaties.
Thanks Dancer for confirming I just need to work harder.
 

·
Registered
Joined
·
618 Posts
Discussion Starter · #7 ·
Thanks, I actually got some out and thought "here goes nothing" and it worked.

When removing the case this popped out, so trying to figure out what and where it goes.
Brown Wood Grey Metal Concrete
 

·
Registered
Joined
·
618 Posts
Discussion Starter · #12 ·
The small washer a small snap ring are all that is left but I’m puzzled how they go in the motor case. I’ve been at his all day, what am I missing?
Tire Wheel Automotive tire Motor vehicle Alloy wheel
 
1 - 6 of 6 Posts
Top