Better get a bearing too. I don't believe there should be much of any slop there. Not that much anyway!
Trans output shaft question.
Hi ya'll,
can someone tell me if there should be any side to side movement of t-92 (?) transmission output shaft. I've got better than an 1/8 of an inch measured at the end of the shaft. Its coming apart regardless, for inspection at the very least, but i wasn't ready to tear into it yet. I'm ordering some other parts in the near future and reckoned i got everything i needed on one shot.
any help is obliged.
mike
can someone tell me if there should be any side to side movement of t-92 (?) transmission output shaft. I've got better than an 1/8 of an inch measured at the end of the shaft. Its coming apart regardless, for inspection at the very least, but i wasn't ready to tear into it yet. I'm ordering some other parts in the near future and reckoned i got everything i needed on one shot.
any help is obliged.
mike
1 - 3 of 3 Posts
thank you Jeff.
i've already got the tractor in pieces and didn't want one more unfinished dissassembly sitting on the bench.
mp
i've already got the tractor in pieces and didn't want one more unfinished dissassembly sitting on the bench.
mp
1 - 3 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
My Tractor Forum
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Top Contributors this Month
View All
MARK (LI)
433 Replies
PA318Guy
367 Replies
Ariens93GT20
322 Replies
Recommended Communities
Join now to ask and comment!
