[finnster123]

UNCLE!!!!!
I can't get the ORC off my 9N PTO shaft. Instructions are unreadable (they could have at least put the sticker on to be read from the back of the tractor!).
Can someone help me out so I can get to the pto seal?
thanks,
rick

 

[PBYAN2]

Should not be too hard.
Remove grease fittings, Line up grease fitting holes with the roll pin that holds the thing on, Drive out the pin and it should come right off.

 

[finnster123]

Thanks,
couldn't remember if it was a pin that went in or internal tabs in ORC. I'll take another look.
rick

 

[finnster123]

Thanks PB!
It's off!
Tomorrow the seal.
Rick