My Tractor Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
:crybaby:Hi everyone
Well, with 450 hours on my 45 hst in six months something had to go. The shift arm has a shear pin connecting the shaft to the arm that is hard to get to between the left tire well and the transmission. It looks like a 3/16th by 2inch.Does anybody know for sure and can I use a nut and bolt instead?
Thanks
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #2 ·
OOPS, found out it is roll pin that can be found at auto parts stores pretty much everywere.
Thanks to a dealer parts person who knew what Iwas talking about.
 

·
Registered
Joined
·
484 Posts
I am having this same problem on my ct 450 its the third one in 350 hours. I was thinking about the same thing with the bolt.
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #4 ·
As a temp fix I cut the end off an old screwdriver. Replacement pins come in different harder metals so look for them and buy five a a time.
 

·
Registered
Joined
·
484 Posts
Ok temperally im using a little bolt that goes through it. I might have to go to the dealer and pick some up.
 
1 - 5 of 5 Posts
Top