My Tractor Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
259 Posts
Try pipe

I made a different kind of edge for a guy that has a loose stone drive, I used a piece of pipe, just cut it down the weld seam and it opened up as i was cutting along, didnt have to do any widening, beveled the slit a little, drove it on with a hammer, it was nice and tite, I welded on a small piece of chain and bolted it to the top of the blade, It work good for loose stone drives, and rode well over soft ground, If you need a sharp edge for packed snow you can pop it off pretty quick, Also you could use a small chain binder cliped to the top of the blade for faster install, removal :trink39: Eric
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top