My Tractor Forum banner
1 - 6 of 6 Posts

·
Super Moderator
Joined
·
29,568 Posts
Discussion Starter · #1 ·
my wife's Uplander has a broken strut mount and a worn out tie rod end. The local tire shop does not want to do the repair as they say you have to pretty much strip that side of the vehicle to do it. The dealer is going to want and arm and a leg to replace less than 100.00 worth of parts so i thought i would check into doing it myself.

anyone have a clue where i can find a manual for a 2006 Uplander to see what is involved?
 

·
Super Moderator
Joined
·
29,568 Posts
Discussion Starter · #4 ·
have not looked at Orielly's yet, was in AutoZone the other day and all they carry is Chilton's which does not list the Uplanders that i saw.

yeah, it is the minivan/SUV crossover. They tire shop said what he saw in teh procedure was you had to remove the freaking windshield wiper for the passenger side and a bunch of other stuff. he said he COULD do it, but that they generally don't like to do jobs that will take more than 1 day. jsut too much work and he would not feel right about the charges. The dealership said that they could do it for 250.00 labor plus parts, BUT we have to buy the parts from them and get them to do teh alignment. by the time you total it out it comes to about 1k. whereas the parts alone are only about 75.00, plus 30 for the alignment from teh tire place.
 

·
Super Moderator
Joined
·
29,568 Posts
Discussion Starter · #7 ·
yeah, parts and all the dealer is almost 1k to do it. i can get the parts at any local parts house for under 100.00, the dealer wants about 500 for them!

i have done it before in the past on older trucks/vans, but not on a minivan. i have a buddy i might can get to help who has the compressor for the spring. worst case is i borrow it from him or go buy my own/borrow from Autozone/Oriellys.

there is one other place in town besides the dealer that i would TRUST to do it, i gotta run teh van by there to see what they say though.
 

·
Super Moderator
Joined
·
29,568 Posts
Discussion Starter · #10 ·
well, i did the strut mount this afternoon. it took a while but was not really that big a deal. of course, there was not a loaner/rental spring compressor to be found so i bought a 35.00 one from Orielly's. probably never use it again, but now i have it if i need it.

the wiper removal was the tough part. there is a funky rod connecting the 2 in addition to the actuator arm. this 2nd rod does not appear to come apart, so i had to remove the motor from the mount, undo the mounts on both wipers, remove the wiper resevoir, then work the mounts out as a single unit the width of the van. once that was out of the way it was a piece of cake. i actually started unbolting the old mount at about 6pm. by 8:30 i was going for a test drive down the road!

i am gonna call the tire shop monday and see if they will replace the tie rod end since it has to have an alignment anyway. the end should be a fairly normal job, nothing in the way of it, so hopefully they will do it. i think they just did not want to fool with the removal of all the crap in teh way of the strut mount!
 

·
Super Moderator
Joined
·
29,568 Posts
Discussion Starter · #16 ·
well, reviving an old thread because this peice of junk has broken the same mount AGAIN. this is the 2nd time since i replaced it, about every 15k miles it pukes the front passenger side mount. good thing is the part is warrantied from Orielly for life, so hopefully i don't have to buy another one. though since they already warrantied it once they may not honor it again. bad news is i leave Tuesday heading out of town for 2 weeks so she has to drive it with a broken mount and me 900 miles away.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top