My Tractor Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
Setting up to remove crankcase cover(oil pan) to inspect and clean. Is there any trick or problems to watch for? Have removed all bolts and it seems hard to pull. Is there anything I missed? Don't want to brake anything will use a Dead Blow Hammer since it's not pulling off. So any thoughts before I get a little more aggressive?
95 18hp B&S (M) 42707
(T) 121401
(C) 9501205B
 

·
Registered
Joined
·
39 Posts
Discussion Starter · #2 ·
Found the problem,it was me!

Found problem, didn't look close enough. Can't believe I missed the recessed bolt and glad I didn't start forcing it. So thanks for looking.
Charlie
 
1 - 2 of 2 Posts
Top