My Tractor Forum banner

Rebuilding front pto

2481 Views 7 Replies 7 Participants Last post by  ricohman
Has anyone taken apart and re installed a case 446
front pto? I took mine off while doing the repower. But even using the manual I must be missing something because I can't get everything to tighten down right and at the same time leave enough space between the clutch and plate.
1 - 1 of 8 Posts
Just rebuilt the PTO in my 446. The thread was originally about a rattle from the front of the engine. I followed the directions sent by Brian and the advice given to me on the fine forum. Worked great.
Never had to hold the flywheel though.
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.