My Tractor Forum banner

Rebuilding front pto

2484 Views 7 Replies 7 Participants Last post by  ricohman
Has anyone taken apart and re installed a case 446
front pto? I took mine off while doing the repower. But even using the manual I must be missing something because I can't get everything to tighten down right and at the same time leave enough space between the clutch and plate.
1 - 1 of 8 Posts
I just rebuilt my 446 PTO with-in the last few weeks, make sure the spring washers have some spring in them. The old ones I took out were all flat, I ordered all new washers and spacer's from Brian and in less than 1 hour it was like brand new. If you follow the parts diagram for proper placement you should be fine.
P.S. don't tighten anything to tight until it's all together.
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.