My Tractor Forum banner

Rear Push Blade for a 316

3222 Views 17 Replies 9 Participants Last post by  red454
I have an old blade from a 1974 Sears tractor - several years ago I made a mount so I could use it with the manual 3 point hitch on my '67 Sears.

Now that I have a 316, I am going to use it on that tractor, so I made some collars to attach the center lift bar and a lower mount so the blade can pivot up and down.

This is a test fit for now - there is still work to do...


See less See more
1 - 2 of 18 Posts
good job red 454, i bought a 316 last summer for 300, was wanting to rebuild and put a paint job on it, the engine has good compression and no leaks, onan engine, the things is ive never painted anything before, any suggestions
1 - 2 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.