PTO Pully for Johnson Loader

1180 Views 5 Replies 4 Participants Last post by Ken in NJ, Jan 30, 2012

boutin73

Discussion Starter · Jan 30, 2012

Does anyone know where the heck I can get a replacement pto pully for my Johnson Workhorse Loader? I have looked everywhere online and cant find one. The pully actually has the set screws (2) inside the pully itself under the belt. All I can find are pulleys that have the set screw on the side of the pulley on a part that sticks out. This wont work because it would be too wide to fit on the pto with the originall pto pully. I have the original manual but it doesnt even have a parts diagram for anything except the frame! I think it is a 1 1/8 bore, 4inch pulley.
Thanks
Jeremy

Save

1 - 2 of 6 Posts

Ken in NJ

· #2 · Jan 30, 2012

I know someone who makes them .. as a matter of fact he was at my house today and I ordered one for myself .. They are steel and not aluminum like the factory supplied ..

He gets $40.00 each and you wont find them anywhere else that I know of. Pm me if you want his contact info

Save

Ken in NJ

· #6 · Jan 30, 2012 (Edited)

I was going to say the same thing, I've looked at many places for something even close and no luck.

My source is one of the most, if not the most knowledgeable Bolens/Johnson loader guys I've had the pleasure to meet in my bolens collecting years.

It stinks that he is not a PC friendly guy, he'd be one heck of an addition to our forum. He rebuilds them better then new, from top to bottom. I know a few here have met and dealt with him and I'm sure they'd say the same thing.

Need a large frame engine or hydro ? He has them rebuilt and sitting on the shelf. Kohlers, and Wisconsins. Eaton and Sunstrand hydros.

He quoted me $1200 for a completly rebuilt ready to install, tested K-582, and he uses only OEM parts.

Save

1 - 2 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month