My Tractor Forum banner

PTO Pully for Johnson Loader

1179 Views 5 Replies 4 Participants Last post by  Ken in NJ
Does anyone know where the heck I can get a replacement pto pully for my Johnson Workhorse Loader? I have looked everywhere online and cant find one. The pully actually has the set screws (2) inside the pully itself under the belt. All I can find are pulleys that have the set screw on the side of the pulley on a part that sticks out. This wont work because it would be too wide to fit on the pto with the originall pto pully. I have the original manual but it doesnt even have a parts diagram for anything except the frame! I think it is a 1 1/8 bore, 4inch pulley.
1 - 1 of 6 Posts
I know that they are not very wide and that the set screw hole has to be in the botton of the "V" groove. I had a couple made using the original alu one as a pattern.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.