My Tractor Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
180 Posts
Discussion Starter · #1 ·
I bought an ORC at TSC yesterday. It looks easy enough to put on except for one thing thats confusing me. The instrucktions say to take off the grease zerks, line up the holes and install the "spring pin". Now, I looked all over at TSC for a spring pin but could not find it. Right above where the ORCs were on display were some roll pins. Is the roll pin what I should be using? I got the smallest one they had that looked like it would fit. Can anyone tell me if I got the right thing? Thanks and Merry Christmas!!
 

·
Registered
Joined
·
180 Posts
Discussion Starter · #7 ·
Thank yall for the replies. I got the correct shaft size so I just need to go to TSC and get them to get me another one from a diffferent ORC. Thanks again for the info!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top