My Tractor Forum banner

Onan P218 starter Solenoid bolt size?

3812 Views 7 Replies 4 Participants Last post by  oldyankeebarn1390
Anyone know the size and length of the two bolts that hold the starter solenoid in place on a Onan P218G? Looks (based on the diameter of hole in the starter frame) to be a 1/4" bolt, probably a metric fastener? Trying to do this without pulling the engine. 9*F in the garage today and have to work barehanded because of space limitations.

1 - 1 of 8 Posts
I do not know the bolt size either, but if you were to call a JD dealer they might tell you. It would probably require them to look up the part number, then measure the bolt. Pretty sure the JD dealer I get parts from would do that, but then if I went to one where I didn't buy much they might not.
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.