Oil Level On troy Horse with Honda Clone Engine

686 Views 3 Replies 2 Participants Last post by mla2ofus, Nov 28, 2015

3macs1

Discussion Starter · Nov 27, 2015

I know many of you guys are running these honda clones on your horse tillers and I was wondering if you fill the oil level differently or something else to make up for the angle the motor will be running at when tilling deep
I don't want to disconnect the low oil level switch
Thanks for the feedback

Save

1 - 2 of 4 Posts

mla2ofus

· #2 · Nov 27, 2015

Another member, I don't see him post anymore, told me he ran his oil fill side tire up on a 2x4 and filled to that level. I did it w/ mine and the low oil switch would still kill it when it was sunk all the way in so I disconnected the lo oil switch and after 4 yrs no harm done.
Mike

Save

mla2ofus

· #4 · Nov 28, 2015

They probably dirty the oil because the chinese machining finish doesn't compare to Japanese finishing.
Mike

Save

1 - 2 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month