My Tractor Forum banner

New to me tn65 no 1 or 2 gear

2053 Views 5 Replies 3 Participants Last post by  AaronK2021
I recently bought my friends 2000 tn65. It had been at our hunting club and sat far 2 years, (he bought a new one with a feont end loader) other than a leaking seal it was running fine when parked. Engine runs great, the shuttle works great, the a/b works fine......but 1-2-3-4 shifter seems to only have 3 and 4. It shows an H pattern on the shifter but I can’t get it to move left, just forward and back. Maybe I am doing something wrong or there is a trick to it? Maybe something in the shifter? I went underneath and the shaft that goes into the transmission does not move in or out (I assume it is supposed to). I really like this tractor as it is replacing my mid 70’s Massey Ferguson. Just wondering if Anyone had any experience ir ideas.

Thank you
1 - 3 of 6 Posts
I contacted a local farmer who only uses NH equipment, I think he is going to come by this weekend and give me a hand
It is definitely bound up. There is a grease fitting on the shift mechanism....took a while but I finally got some grease in there....added heat and more grease iver several hours now I have all four gears! Yay!
1 - 3 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.