My Tractor Forum banner

My RF project almost done! But...

966 Views 11 Replies 4 Participants Last post by  Green&Yellow
So I can't get the speed disc/ governor arm adjusted right....

When I tighten the nut down I can't move the throttle but when I loosen it up the it keeps loosing itself and will allow the engine to over rev. Feast or famine.
1 - 1 of 12 Posts
Not much help because ingenerally have to fuss with the governor for a few hours before I can get it set where it needs to be! Follow Small Job and LTGs notes and comments :fing32:
1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.