A sleeve hitch is a one point hitch that requiers one pin to attach a implement like a rear blade or a turning plow. a 3point hitch has two lower arms and one center link to to raise and lower attachments like a plow or Blade and has 3 point's of contact one on the left side and one on the right side and on on the top center. Here are two links to help you out on your 300. The first if you want to add hydraulic outlest and levers http://aux-hyd.com/ and the other will help with restoration and info on your 300 http://weekendfreedommachines.org/ :thThumbsU
My 1978 JD 312 project pictures
Well, here it is. My deceased grandfathers 1978 JD 312. It's been sitting for quite a few years now, and I've decided to "restore" it. I've already got lots of help from you...so thanks!
You might see my little JD111 I rebuilt a few years ago...
It doesn't look like much, it's a little more rusty than I was hoping, but I think it's worth it. It only has the single hydraulic deck control valve, so as far as I understand I need to get a H3 control valve to operate some hyd goodies? Any input is much appreciated
thanks again,
Ryan
You might see my little JD111 I rebuilt a few years ago...
It doesn't look like much, it's a little more rusty than I was hoping, but I think it's worth it. It only has the single hydraulic deck control valve, so as far as I understand I need to get a H3 control valve to operate some hyd goodies? Any input is much appreciated
thanks again,
Ryan
Attachments
1 - 1 of 11 Posts
1 - 1 of 11 Posts
