My Tractor Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
I registered to this forum just so I could thank you, Toolin, for you post. I followed your design and it works great! I'm not sure I would have believed that it would work at the angle that you have to position the actuator if I didn't see your video of it working. I foolishly tried to place it lower for a steeper angle only to find out that it gets in the way of the blower as it rises. Even seeing yours working it was difficult figuring out the dimensions and angles so everything would align and work smoothly. I know this would have been a lot more work for me if I didn't have your plan since I obsess over details and often take forever to make a decision. In the end it only took me two weekends. I've used it twice already - saving me time, elbow and shoulder pain. Thanks so much for you post!!!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top