monkey ward gil 1585D

890 Views 8 Replies 3 Participants Last post by richard rahl, Sep 14, 2020

richard rahl

Discussion Starter · Sep 3, 2020

Hello i got this tiller for free and its problem was no spark. The coil pack does not have a connector up top so to replace/remove I have to take off the flywheel. The issue with that is in front of that there is a aluminum bracket that was part of the recoil system. After soaking the aluminum bracket in oil for a few days it would not come off with a puller. So like the impatient person i am i put heat to it and melted it (facepalm). I cannot find the model information anywhere Model # Gil 1585D Ser # 526202 534

See less See more

Save

1 - 4 of 9 Posts

richard rahl

Discussion Starter · #4 · Sep 6, 2020

Crap that would explain it than. Thanks all

Save

richard rahl

Discussion Starter · #7 · Sep 12, 2020

I am going to guess the flywheel would also be threaded than? Or would it be a press on. There are two threaded holes next to the shaft for what looks like a puller.

Save

richard rahl

Discussion Starter · #9 · Sep 14, 2020

MoJoMowerman said:
No problem. Save the little round balls. Their hard to find. Let me know if you need a new used one.

Where you meaning the balls or the aluminum clutch? Cause i obviously need the clutch, saved the balls though.

Save

1 - 4 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month