My Tractor Forum banner
1 - 1 of 1 Posts

· Registered
222 Posts
Discussion Starter · #1 ·
I recently picked up a b5100e and have been doing some reading. I'd like to put a blade on it for snow removal and possibly another front attachment or two but from my understanding, I need a diverter valve from a 6100 or 7100 to run a cylinder up front. Is this accurate? Can I use a front cylinder without this valve? Where could I find one?
I've looked around online and have not found a source for this valve.
Would it be better to run this new line in to a valve block to possibly run a life cylinder and a angle cylinder as well? If you have any pics of your setup I'd like to see them.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.