My Tractor Forum banner

Kohler K241 ?'s

10598 Views 16 Replies 7 Participants Last post by  Newsman
I was out messing around with the throttle linkage today. High idle used to be 1,440 rpms unloaded. Now it'll hit 2,200+ rpms loaded, but it sounds 10x's louder. Also before the throttle lever would easily control the rpm and now it seems to wonder around. I'll set it around 1600 rpms and it will slowly increase to ~2000 rpms or so.

Now it mows just as fast in second gear as it used to in third and I opened her up in fourth gear on the road and it felt like I was going quite a bit faster then the 8 mph the John Deere service manual says the max speed is.

All the rpm readings came from my knock-off add on digital tach. So I don't know how accurate that is. I'm starting to wonder if I was over revving it. The engine sounded great. Like it was on steroids. As far as I know is completely factory except for the exhaust stack I put on, which you can look straight through the muffler.

I'd really like to grab my gps and see how fast it'll go, but I'm afraid of damaging it.

Also I could not adjust the idle speed. It was either ~1140 rpms or it was dieing. So I think I need to re-adjust the High/Low idle speed screws. The manual says to turn out the High screw 1.5 turns and the Low screw 2 turns.

I don't understand how the governor linkage is suppose to be set up. I moved the spring in between the governor arm and other arm that connects to the throttle cable and thats how I got the rpms to raise above 1440. I adjusted the adjustment screw on the throttle arm (?) until the spring sat loose on the governor arm at low idle. But that seems to be where I messed up the throttle lever. Unless that adjustment screw has to much tension still and is pulling on the throttle lever too much or something.

Can someone shed some light on this?

Also, is the low idle only controlled by turning the idle speed screw? It seemed like the engine took forever to change rpms after adjusting the screw.

:thanku:
See less See more
1 - 1 of 17 Posts
2
Like this.



Just search the net for small engine throttle cable clamps

BTW you'll also need the small screw that clamps them down.
MikeC
See less See more
1 - 1 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top