My Tractor Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hello everyone,

I have a John Deere 110 patio mower that I’m restoring, it has the K181 motor on it and I’m looking for a block or looking to use this block but am a little skeptical about it. I’m open to all answers thank you!

Ryan
Motor vehicle Automotive lighting Automotive tire Hood Light

Automotive tire Grey Automotive wheel system Auto part Tints and shades
 

·
Three of my friends
Joined
·
9,535 Posts
Just have it bored and new piston an rod n piston,good as new but first have it mixed to assure it needs bored,might just need honed
 

·
Three of my friends
Joined
·
9,535 Posts
Did the rod crack that piece off,I would smooth that out ,it only sees the bottom of the piston
 

·
Three of my friends
Joined
·
9,535 Posts
If you hav3 honed before,forget this,the hone marks must close to 45 degrees,so up n done movement is fast to active this
 
1 - 9 of 9 Posts
Top