[willy22]

Am having trouble keeping deck cutting level. Cuts fine until I make sharp turn or run over uneven ground. Seems like deck hangs up on one side, but when I check, it isn't. Hangers were wore, so I welded up and re-drilled. Not the problem. Could it be something in steering or chassis that is changing? Am getting frustrated and about to sell it.

 

[Jim_WV]

Check to make sure your tire pressure is up. I found on my old JD that the tire pressure in the right rear was way down from the other side and would cause the same thing you describe. Your manual should list the proper pressure to have or it could have a chart under the seat :dunno:.