My Tractor Forum banner

John Deere 212/Snowblower mounting question

10754 Views 13 Replies 7 Participants Last post by  PA318Guy
I have a John Deere 212 and I just recently purchased a Snowblower for it. I have had numerous issues getting it hooked up. First, I didn't have the lift linkage. Once I got that I was moving again. Then, my lift motor went out. I never did fix that because the cost is way to much. I'll just keep the snowblower in the down position.

Now I have it hooked onto the frame. Their appears to be one more piece missing and I don't know what it's called to look for the part. It's the pulley on the mower that the snowblower belt wraps around. The only pulley that is there is inside the engine (it's what the belt to the mower deck hooks onto). My dad said there is a spot for another pulley to hook onto. It has three holes were it can be mounted. Here is a picture of a pulley that looks like it would fit although I'm not sure it's the right one:

http://www.ebay.com/itm/ws/eBayISAP...588+&item=150726278588&lgeo=1&vectorid=229466

That isn't my listing. It's the only picture of a JD pulley I could find where the big inside hole and the three smaller holes look like it would match. Any ideas? Is this what I need? Any help would be greatly appreciated.
See less See more
1 - 1 of 14 Posts
The guy I have work on my mower says that he thinks it needs a different left-side foot panel because the cutout for the manual lift is different from the electric lift. Does that make sense since you have done this before?
Nope, its the side panel of the dash tower, as Keith stated.

Attachments

See less See more
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top