JD 400 dimension from pto to center of engine pulley
I was hoping that someone could let me know what the dimension is between center of the engine pulley and center of PTO is on a 400. I inherited a repowered 400 that never had the PTO hooked up. I got most of the parts to connect the PTO, but the engine pulley seems too low since it hits the tensioning pulley. Any help would be appreciated
1 - 1 of 2 Posts
1 - 1 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
My Tractor Forum
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
