JD 400 dimension from pto to center of engine pulley

1494 Views 1 Reply 2 Participants Last post by Merc1973, Jul 23, 2019

randynh1979

Discussion Starter · Jul 23, 2019

I was hoping that someone could let me know what the dimension is between center of the engine pulley and center of PTO is on a 400. I inherited a repowered 400 that never had the PTO hooked up. I got most of the parts to connect the PTO, but the engine pulley seems too low since it hits the tensioning pulley. Any help would be appreciated

Save

1 - 1 of 2 Posts

Merc1973

· #2 · Jul 23, 2019 (Edited)

What engine PTO pulley are you using in the Vanguard? Also depends on tje engine cradle mount. I would call up Small Engine Warehouse and see if you can buy just their pulley, matching PTO idler pulley and matching belts. But you would have to Be using the SEW engine cradle as well i suppose.

See less See more

Save

1 - 1 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month