Hydraulic Hoses

Ummm, 600 rpm? What kind of speed reducer are you planning on using to get it down to a reasonable speed.

Even the A125 is too fast at 188 rpm, but at least its doable with some creative reduction.

If you can't get the chute rotation down below 20 rpm (3 seconds for a full 360* chute rotation), forget about it!

So a flow control is part of the circuit. That makes more sense.

I do understand why it is on the blower with the layout of JD hydraulics, but adjusting it for the correct speed is not going to be as easy as it would be of it was within reach of the operator.