My Tractor Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
I have a 322 I know I can install a 3pt or a sleeve hitch and the hydraulics will lift it but I have been trying to see HOW it lifts it and am not finding anything. I have a plow I want to try to install on the back but can't figure out how it lifts.

I know it is a stupid question but thanks for any help on where to find it.
 

·
Registered
Joined
·
2,189 Posts
You replace the stock rockshaft in the rear of the frame with a new one that has ears for lift links that rotates and lifts the 3 pt arms.

Not sure on a sleeve hitch for a 318
I know you can get a sleeve hitch adapter to go on a 3pt hitch.

The 3 pt would be more versatile and useful. If you were to invest I would suggest a 3pt.
Check out ruegg mfg. GREAT hitches.
 

·
Run ahead of the pack
Joined
·
9,968 Posts
You have an hydraulic cylinder under the tractor connected to a rockshaft, that it's use to lift the 3 point hitch.

 

·
Super Moderator
Joined
·
16,690 Posts
Last series of JD 300 to Take a Integral Hitch Sleeve Hitch was from one of the Following Models
300
312
314
316 Kohler
317
The 316 Onan and above Did not Have a Integral Hitch (Sleeve Hitch ) Made for them. So for the 322 The Only thing available was a Cat 0 3point Hitch but we did have a Member Modify a Integral Hitch from a older 300's series to fit On a 318:thThumbsU
 
1 - 4 of 4 Posts
Top