My Tractor Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
476 Posts
Discussion Starter · #1 ·
I'm almost finished building my rear blade for my Bolens 1250. All I have left to do is drill position holes for the angle and tilt positions. Paint eventually. I'm trying to decide how I want to put the pins in. It would be nice if I could make something so I can do it from the seat. Not gonna spend the money on an actuator or hydraulics. It's got both angle and tilt capability. I can spin the blade backwards too, but that picture will not load. I just used what I had laying around the shop and the blade is an old unused scraper blade. It's 6 1/2" high with a curve. Think it will work good. Only going to really be using it on my 600' dirt driveway. After years of plowing my driveway has a reverse crown. All the dirt is built up on the sides. Gotta get it back in the middle.
 

Attachments

·
Registered
Joined
·
476 Posts
Discussion Starter · #3 ·
Best to be safe and build heavy. I plan on building a wieght box for the frame that I can bolt on. Just unbolt the blade and bolt on the box.
 
1 - 3 of 3 Posts
Top