My Tractor Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1 (Edited)
Live in Holland Michigan
Need support on my John Deere R92 rear engine mower
my steering "gear pin" will not stay in the sleeve. Is there a bushing that needs to be in this area or will the "pin to sleeve" need to be welded?
 

·
Retired Super Moderator - Deceased September 2015
Joined
·
26,679 Posts
Re: Hi Introduction

:MTF_wel:Glad you joined!
:wwp: If you need easy Picture help
Be sure to Register for Your State!
 

·
Super Moderator
Joined
·
16,490 Posts
Welcome to the Forum:MTF_wel:
 

·
Super Moderator
Joined
·
32,656 Posts
Welcome to the forum! I know right where you are at. I came out there last year and picked up a JD 318 and tiller in Holland. Sorry not much knowledge with the RER's but someone will be along in a few to help! Here's the place I picked the tractor up at! A-1 Mowers 891 Lincoln Ave., Holland, Michigan!
 

·
Registered
Joined
·
4 Posts
Discussion Starter #7

·
Registered
Joined
·
4 Posts
Discussion Starter #8
Welcome to the forum! I know right where you are at. I came out there last year and picked up a JD 318 and tiller in Holland. Sorry not much knowledge with the RER's but someone will be along in a few to help! Here's the place I picked the tractor up at! A-1 Mowers 891 Lincoln Ave., Holland, Michigan!
**Thats awesome! Yep I'm only 6miles from where you picked the JD 318.....
 

·
Registered
Joined
·
4 Posts
Discussion Starter #9
1 - 10 of 10 Posts
Top