My Tractor Forum banner

greasing the RER

1524 Views 10 Replies 6 Participants Last post by  Dude11
got the new clutch disk in, the blade sharpened and now started greasing the fittings in the deck, wheels.. Whats odd is that even after I clan the zerk fittings and even push in the spring loaded ball to be sure the fitting are not frozen, when I grease em , all the grease comes out around the zerk and nothing seems to be going in .. hmmm. Are there such things are metric vs standard tips on the grease guns or something? It seems to snap on nice and tight..
1 - 4 of 11 Posts
does not seem like it.... Ill remove a fitting to see inside I guess
its weird. ALL of them?? hmm
ok pulled off a few and saw that the grease was getting thru fine... Guess I was pumping too much and the unit has few hours so the bearings were pretty packed with grease already.. Thanks all
1 - 4 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.