My Tractor Forum banner

Ford LGT 125

12345 Views 17 Replies 6 Participants Last post by  Utah Smitty
Hi i'm new to the site and i'm having a few problems with our Ford Lgt 125 if anyone can help us, we'd greatly appreciate it.

I have all numbers on tractor
Model no#09JC3221
Serial no#G120409
Engine no#K301AQS
Spec no#47606
Engine Serial#12130937

1st) the starter is turning the engine left:fing20: isn't the starter supposed to turn left so the engine can turn clockwise?
2nd) the engine would run great for 10 to 15 minutes and then shut off what would cause that?
3rd) tractor went to a guy and he made a mess of the wiring and the pto's wires are missing and the ignition wiring is :eek:mg: I don't know!!!!!!!!!!

does anyone have the wiring diagram for a 125 or a manual?

Tractor Has:
660 amp diehard battery
12 hp K301 engine
4 speed manual transmission
75 lbs. rear tire weights x2
side panels for hood were lost in garage fire 3/25/08
sleeve hitch, cultivator, plow sleeve, disc harrow, dozer blade, mower deck 44?-46?

Tryin to plant a garden this year, but it may be too late by time tractor is useable!!!:sidelaugh
1 - 2 of 18 Posts
1st) the starter is turning the engine left:fing20: isn't the starter supposed to turn left so the engine can turn clockwise?
2nd) the engine would run great for 10 to 15 minutes and then shut off what would cause that?
3rd) tractor went to a guy and he made a mess of the wiring and the pto's wires are missing and the ignition wiring is :eek:mg: I don't know!!!!!!!!!!

does anyone have the wiring diagram for a 125 or a manual?



Not understanding your 1st question....If the engine is starting, its turning the right way......it won't run backwards.

Engine shutting off.....Could be a few things,,,,,Coil over heating.....fuel filter plugging up...etc.

PTO....is just power to the electric clutch.....should be easy to rig something.

For a manual.........go to the Ford-Jacobsen group on Yahoo....

http://groups.yahoo.com/group/Jacobsen_Ford_Garden_Tractors/
I'm a little confused on what the starter is doing. You said it's turning backwards? Only way I know how to get a motor to turn backwards is by switching the polarity. Positive to negative and negative to positive. You sure you have the battery hooked up correctly?
If you need a wiring diagram, let me know and I can e-mail you one. :goodl:
Even that won't make it turn backwards I believe.....The starter has to turn the right way for the centrifugal spline to cause the starter gear to slide up the shaft...........:banghead3
1 - 2 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top