My Tractor Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter #1
My first post!
I just got the Ford 3000 a week or so ago. It had been sitting a good bit, maybe 5 hours of use over the last couple of years. So its running a little rough, poping and so forth. I am going to give it a good going over and tune up. The problem I am having is finding a source for instructions on rebuilding the carb. My shop manual doesn't have much at all, kind of disappointing. Maybe I am just over thinking it. I have done several carb rebuilds over the years and it seems I would normally have some basic instructions with the rebuild kit. Mine came with just the parts. Where do I start with the mix screw, one turn out? and so forth....
:thanku:
 

·
Premium Member
Joined
·
5,674 Posts
I usually start with a turn and a half out on both screws to get it to start start then adjust from there after I get it up to temp.
 
1 - 2 of 2 Posts
Top