My Tractor Forum banner
Cancel

engine case argggg!!!!!!!!!!!!!!

3255 Views 7 Replies 6 Participants Last post by  larrybl, 
S
10 HP Briggs, while trying to pry off the flywheel, I punctured a hole in the top of the case. (I did try to use the pulley first but it still wouldn't budge so I used a large screw driver to help, bad move). Anyway their is a small square hole, around 1 inch by 1/2 inch. Can a patch be welded over the whole or can you patch it with JB weld? Any other ideas?

Thanks
Save Share
1 - 2 of 8 Posts
larrybl
http://www.mytractorforum.com/showthread.php?t=220408

The consensus is to remove the engine, Pull the engine apart, LOCATE THE BROKEN PIECE!, and JB Weld it back in place.
Save Share
Reply Quote
larrybl
:thThumbsU:dancingpa:wwp::wwp::wwp:
Save Share
Reply Quote
1 - 2 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
My Tractor Forum
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
John Deere Forum Craftsman/Sears Forum Backyard Round Table: L & G Tractor Related Topics Introductions Walk Behind Mowers
Top