engine case argggg!!!!!!!!!!!!!!

3261 Views 7 Replies 6 Participants Last post by larrybl, Jan 7, 2012

samahi72

Discussion Starter · Dec 23, 2011

10 HP Briggs, while trying to pry off the flywheel, I punctured a hole in the top of the case. (I did try to use the pulley first but it still wouldn't budge so I used a large screw driver to help, bad move). Anyway their is a small square hole, around 1 inch by 1/2 inch. Can a patch be welded over the whole or can you patch it with JB weld? Any other ideas?

Thanks

Save

1 - 1 of 8 Posts

H-D

· #4 · Dec 25, 2011

I patched a 10 hp BS block holed by a parted rod with linen cloth (bed sheet) & contact/rubber cement. The patch held my brothers until they moved up to dirt bikes (2 + yrs.). Might want to take some pains with the crankcase breather.

Save

1 - 1 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.