My Tractor Forum banner

end play in rear hub.

1938 Views 9 Replies 5 Participants Last post by  skippytdi
on a 1614, the hub pulls in and out about 1/8". Is this a big concern?

1 - 2 of 10 Posts
I still don't think 1/8" is a big deal. Now, if that distance grows, you got problems!
Can extra thrust washers be added to tighten this up some Jeff and would you put them inboard or outboard of the final drive gear?
are the hubs set screwed to the axle on it? if soo, tighten em. if not i'll shut up
shut up. just kidding. Good point and yes they are. thats like taking apart the carb before checking to see if you have gas. or a doctor told my mom, we walk before we run.
1 - 2 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.