My Tractor Forum banner

1 - 1 of 1 Posts

852 Posts
Discussion Starter #1
I have in mind to build a "82" from scratch using a standard tranny. I don't want, actually won't have a lift lever attached, just don't like the look so I gotta figure my way around it. I'm thinking of going the electric lift route, do you think I'll be able to adapt one to a 82 wide frame?|294:50

I was thinking of bidding on this. Any thoughts?

Does anyone have any ideas on a one piece electric pump that will run the hydraulic lift cylinder? I want the overall tractor to appear unmolested, by that I mean I don't want to alter the engine compartment by ading a ps pump as I've seen others do.

Thank you

1 - 1 of 1 Posts