My Tractor Forum banner

Duraforce Rebuild

4476 Views 12 Replies 6 Participants Last post by  LawnBoyDoc
As I was telling Sharkey earlier today, I am knee deep in my Duraforce rebuild. Its all apart and cleaned and I am just about to do a very very light hone on the cylinder for the new rings with my Flexhone (4 passes and one or two fast for cross hatching). I have pics I'll post later tonight, but it appears that the motor sat in a very humid environment or it was watered. Seems the bottom crank bearing had a bit of rust on the lower outside of the crank lip and partially on the bearing casing-couldn't see any on the ball bearings. I cleaned and oiled the crank bearings (both top and bottom ball bearing); the top crank bearing is butter smooth, the bottom crank bearing turns easliy-but it just has a "feel" to it. No where near as smooth as the top bearing.

What to do? It appears the Duraforce crank is ONE STOUT piece. BIG ball bearings!!. And although the bottom one seems a little less smooth it has no more free play than the top one. I don't think I could bend or hurt these bearings with a sledge hammer. Has anyone heard of a Duraforce crank bearing failure??

Also appears that the bearings and crank are one unit. Bearings are not...sold separately ($80.00 for the whole unit at mowpart). Anyone have any experience you can put me at ease or tell me to take out the wallet. :crybaby:
1 - 2 of 13 Posts
Well i have 2 engines that have a good amount of play in them. I have heard that you can switch the bearings in these and people have done it.
1 - 2 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.