It is a splined axle and I did forget to mention that when I used my porto-power I did heat up the hub and it still didnt work. Where does a guy go to get PB blaster.
I think ill give that a shot. Thanks
I think ill give that a shot. Thanks
Does it ever END!!!!
Hi
I just finished my 67 112 and within 2 weeks naturally one of my rear wheel seals goes out!!!! Now I need to pull the hub, so I get my puller and start on it and it doesnt budge, so I threw a little WD-40 on it and tried it again, still nothin. I decided to get my porto power and try that and It still wont budge. So since I am pretty good with my transaxle I decided to pull everything apart except for the differential. Now all I got is the axle in there and I tried my puller, and my porto power and still got nothin. The stupid thing wouldnt budge with 10 tons of pressure, and with my luck I pulled the snap-ring of on the other hub and with a tap of my mallet it came off!!!!!! Does anyone have any ideas on how to get this thing off? Its really startin to give me a headache.
Thanks
I just finished my 67 112 and within 2 weeks naturally one of my rear wheel seals goes out!!!! Now I need to pull the hub, so I get my puller and start on it and it doesnt budge, so I threw a little WD-40 on it and tried it again, still nothin. I decided to get my porto power and try that and It still wont budge. So since I am pretty good with my transaxle I decided to pull everything apart except for the differential. Now all I got is the axle in there and I tried my puller, and my porto power and still got nothin. The stupid thing wouldnt budge with 10 tons of pressure, and with my luck I pulled the snap-ring of on the other hub and with a tap of my mallet it came off!!!!!! Does anyone have any ideas on how to get this thing off? Its really startin to give me a headache.
Thanks
1 - 4 of 9 Posts
Thanks I think today ill give the pb blaster a try today. I should be able to hit the center of the axle with a hammer and push the whole thing out the other side right???
Hey cad plans thats a nice splitter/press
Hey cad plans thats a nice splitter/press
Thanks little tractor guy I didnt have the manual and it was very helpful. I picked up some pb blaster today so im workin on it and hopin it works.\
Thanks
Thanks
1 - 4 of 9 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
My Tractor Forum
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
