I agree with mrbeef, a deep clean at this point will be a great thing. It will make things a lot nicer to put back together too. John Lang is super to work with. You would not be disappointed in his insulation kit.
Deere 318, what to do while the engine's out
Pulled my engine to replace the starter. I figured while it was out I'd check to see if there was any other maintenance stuff I could do before putting it back in.
I remember seeing a post on firewall insulation, but can't find a kit anywhere. Can someone tell me how to do this? foam insulation from HD work?
Shimming the starter. Old starter had no shims, the teeth on the starter looked fair, teeth on the flywheel had a very small amount of chipping on the teeth side facing the starter. Can someone explain the process for this?
Already have a starter improvement kit, the starter itself just died(tested it dead on the bench). Any other simple/quick/easy things I can do while I have the tractor torn down this far?
Thanks!
I remember seeing a post on firewall insulation, but can't find a kit anywhere. Can someone tell me how to do this? foam insulation from HD work?
Shimming the starter. Old starter had no shims, the teeth on the starter looked fair, teeth on the flywheel had a very small amount of chipping on the teeth side facing the starter. Can someone explain the process for this?
Already have a starter improvement kit, the starter itself just died(tested it dead on the bench). Any other simple/quick/easy things I can do while I have the tractor torn down this far?
Thanks!
1 - 1 of 9 Posts
1 - 1 of 9 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
My Tractor Forum
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
