My Tractor Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
79 Posts
Discussion Starter · #1 ·
Today I cleaned and greased the 48" deck on my x350 and also installed a mulching kit on it. Brand new mulching blades and everything torqued to spec. Once I got the deck back on I wanted to test it out a little bit but when I engaged the deck it felt like it was going to shake itself apart. I didn't have time to look hard at it yet but before this I had no issues. Any ideas? Bent or out of balance blade from the factory?
 

·
Registered
Joined
·
79 Posts
Discussion Starter · #4 ·
That is exactly what it was thank you! The newly installed mulch control handle is making some noise too but I don't think there's much I can do about that.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top