My Tractor Forum banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
1,278 Posts
I did take a semester of drafting in high school then known as "Industrial Arts". Looking at the drawing again, the hardest part is thinking about the sequence of cuts. I have a chunk of ground rod, .50" copper, so 1/4"NPT first, then holding it securely without damaging those threads while I make the other cuts.

Bill
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top