changing oil in K46 transaxle...

17628 Views 17 Replies 7 Participants Last post by sproulman, Jul 18, 2009

dkuster

Discussion Starter · Jul 13, 2009

I'm trying to change the oil in my K46HD transaxle, but I'm having trouble locating the fill hole.

I've looked at the diagrams on the Tuff Torq website, and there are two possibilities: One is called a "vent", which has a rubber plug with a hole and a black cap. The other has a metal cap, and the diagrams show a magnet and magnet-holder underneath.

Which one is the correct one to open in order to drain/replace the oil?

Does it just pry off?

Thanks for the help!

-dan

Save

1 - 1 of 18 Posts

c1tobor

· #8 · Jul 17, 2009 (Edited)

Thanks for the info. Been wanting to do mine w/synth. since both TT and JD recommend it. However, I have to wait until the warranty is up or I could have problems with JD if the tranny goes bad...:duh::banghead3 :00000061:

(what tractor do you have the K46 on and did you remove it or pump it out?)

Save

1 - 1 of 18 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month