If the big nut is tight (450 ft. lbs., 170 lb. owner on the end of a 3' pipe!) then it's probably a worn out hub, the axles are harder than the hubs. See if the axle splines are sticking out past the hub preventing the nut from pushing against the hub, if so the hub is worn.
Changin wheel bearing
I dicovered that I have A LOT of play in my left rear wheel on my 8n. So much that I can wobble it while it's sitting on the ground like normal. I tried and searched for any threads on ho to change it but couldn't find anything. Is this a straight forward job? Thanks
1 - 1 of 5 Posts
1 - 1 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
My Tractor Forum
A family friendly forum community dedicated to all Tractor owners and enthusiasts. Come join the discussion about specifications, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Top Contributors this Month
View All
MARK (LI)
409 Replies
PA318Guy
359 Replies
Ariens93GT20
261 Replies
Recommended Communities
Join now to ask and comment!
